Anyone come up with any modifications to make their Dillons run better?
For example:
I run a 550 with a Casefeeder. Every so often a piece of 380 will work it's way in with the 9mm brass. (yeah, I know...I should inspect closer). So now I have a casefeeder that wont cycle onto the shellplate. So rather than dump the entire feeder tube of brass, I drilled small holes in the feeder tube. I can take a bent paperclip and slip it into the holes and keep all the brass in the tube, while I pull the stuck case out of the bottom of the feeder tube assembly.
Anyone come up with anything along these lines?
For example:
I run a 550 with a Casefeeder. Every so often a piece of 380 will work it's way in with the 9mm brass. (yeah, I know...I should inspect closer). So now I have a casefeeder that wont cycle onto the shellplate. So rather than dump the entire feeder tube of brass, I drilled small holes in the feeder tube. I can take a bent paperclip and slip it into the holes and keep all the brass in the tube, while I pull the stuck case out of the bottom of the feeder tube assembly.
Anyone come up with anything along these lines?