dennishoddy
Moderator
Got the JP trigger put in yesterday. Big learning curve, or maybe it was the pin locations in the receiver.
The original pins were nice and tight, but in the process of putting the trigger assy in and out for the disconnector timing, and getting the safety ramp set, the holes got a little loose. The oversized JP pins covered that issue.
I took it to the farm, as the range was too wet. Man, that trigger is nice. I didn't try any rapid fire, as I was concerned with making sure the safety and dissconect worked properly. I had to remove another .021 before the safety would work properly. Took my time and did it right.
The original pins were nice and tight, but in the process of putting the trigger assy in and out for the disconnector timing, and getting the safety ramp set, the holes got a little loose. The oversized JP pins covered that issue.
I took it to the farm, as the range was too wet. Man, that trigger is nice. I didn't try any rapid fire, as I was concerned with making sure the safety and dissconect worked properly. I had to remove another .021 before the safety would work properly. Took my time and did it right.
