PCC Trigger Install

PeteMcGuire1881

Well-Known Fanatic
Joined
Dec 22, 2016
Messages
163
Location
Indiana
So I installed the Rise Armament trigger in my PCC lower with the KNS anti-roll pins and I have a gap (see picture). Everything seems to be seated properly and the screws are tight. Is this normal?
6058dec489389fbddb14ae6d24ca0bd6.jpg



Sent from my iPhone using Tapatalk
 
Register to hide this ad
Yeah, I've not seen any pin sets that don't have a little space. Same for the ambi safety levers. Most likely to allow for thicker than mil spec receivers.
 
Back
Top