PCC Trigger Install

[PeteMcGuire1881]

So I installed the Rise Armament trigger in my PCC lower with the KNS anti-roll pins and I have a gap (see picture). Everything seems to be seated properly and the screws are tight. Is this normal?

Sent from my iPhone using Tapatalk

 

[Matt1911]

It's the same with the 3 sets of KNS pins I have.

 

[PeteMcGuire1881]

All I needed to hear. Thanks!


Sent from my iPhone using Tapatalk

 

[Wall]

Yeah, I've not seen any pin sets that don't have a little space. Same for the ambi safety levers. Most likely to allow for thicker than mil spec receivers.

 

[59nolimit]

I have 2 of them in ar15 rifles. They don't have that much gap but they do have a little.