What to use on Loki billet for a bolt release?

[fastarget]

Usually use a Magpul " bad lever" on my rifles, but it does not look like it will fit on the loki due to the design. What other options may be available to create an ambi release?

 

[Wormydog1724]

Phase 5 makes one that looks a lot like the Magpul bad so it may not work either. that's all I know of.

 

[Matt1911]

Shave the width of the bad and tac weld it on.

 

[Topshotdudley]

I have the phase 5 on my loki it works amazazing no problems!

 

[Wall]

I have the phase 5 on my loki it works amazazing no problems!

is your loki a billet set or a forged set?

 

[nikatkimber]

Troy has an ambi bolt release too.

http://www.midwayusa.com/product/195300/troy-industries-ambidextrous-bolt-release-ar-15-matte?cm_vc=subv1769721

 

[Matt1911]

The recessed portion of the upper that accepts the bolt release on the Billet sets is too small to accept the screw on parts.
I wasn't being a Smartass before, your best option is to shave down the b.a.d. lever and weld it on the bolt release. You can make it look good if you take the time to smooth it out then hit it with some krylon.

 

[fastarget]

is your loki a billet set or a forged set?

Sorry should have said Billet.......nice and sturdy, beautiful fit and finish, but I now wish it had an ambi set up, however now that Matt mentions it, I might go for heliarcing the magpul or possibly one I can make on, it may be the simplest and less costly option.