New Shotgun Caddys from TACCOM

[jtischauser]

Tim Ubl from TACCOM has been working on some cool new shotgun stuff among other things. Here is his new 4 Up Quick Caddy for weak hand loading and the 4 Up Quad Load Thingamajig. I haven't spent more than one or two 15 minute sessions playing with them but I like what I see thus far. The 4 Up Quick Caddy's load even easier than my Man Mountain Caddy's.

http://www.taccom3g.com/QUICK_CADDY.html

Check them out...

 

[benjamin-benjamin]

well his price is much better.. especially on the quad loading.

 

[Remington Reed]

I don't see the load 4 up one on their site, when will it be out ?

 

[Wall]

I'll have them today

 

[jtischauser]

They sent me some prototypes to play with. They are making revisions. Send Tim a message on facebook. He might have some ready to go.

 

[Wall]

yes, I'll bring some

 

[Dustin Cantrell]

I have a Taccom 16 up belt line dual load. I like it a lot. I think I'm going to have to put an additional fastener on the back of them to keep them on the nylon web belt. Tim's current version might be a little different. If you plan on putting them directly on your comp belt I don't think you'd have the same problem. The nylon web belt is very thin and tough for it to hang on to. I've been strapping them around my stomach to get them up higher and right by the loading port to load weak hand.

What I really like about Taccom is Tim Ubl. I had an issue with one of his products. I shipped it to him and he had repaired and tested and shipped it back within a couple hours of him receiving it. A week or so later he called me and chatted on the phone for probably 10 minutes. He wanted to make sure it was working properly and I was happy. I'm not aware of many business owners that would do that. He made a good impression on me and I'll continue to buy products from him.

 

[LoneStarSOF]

I like these Caddy's, how sterdy are they on the belt. Are the Shells easy to strip out, looks like it might twist on the belt as your trying to pull the shells out.

 

[jtischauser]

I mounted mine to tek locks. The free attachment hardware they come with works good on a cr speed type bent but it isn't fast to take them off and put then back on because you have to tighten them down a lot to keep them from twisting.

 

[Wall]

I talked to Tim this evening & he wasn't able to get those ready to ship this time.
He thinks he should be able to get them ready to ship to me at the end of next week.

 

[Wall]

FABULOUS! Price point?

not sure yet but I think somewhere around the $39 mark

 

[Shooter116]

Is there enough room on the 4ups to attach a ELS plate to it? How about the load 2's?

 

[jtischauser]

I don't know what an ELS plate looks like.

 

[giarc01]

I was going with load 2's but the price on these is hard to beat.