AR gold trigger question

[Tech]

I installed a new AR gold trigger in my rifle. The safety seems to be sluggish and a little sticky. It's not as crisp on and off like my other rifles. Has anyone else experienced this? It looks to me it might be just the design of the trigger?

 

[G Tinney]

They're tight when new, it will wear in. I added some lithium grease between the two and that helped a lot.

 

[mike cyrwus]

I fit the safety to all my AR golds

 

[Tuflehundon]

When I added my HiperFire 24C, I had issues with the safety sticking as well. I had a couple of different brands of safety's laying around, so I swapped them out till I found one that worked right. If I didn't have the extra's laying around I would have fitted mine like Vyrus said. A lot of your aftermarket trigger upgrades have tighter tolerances.

 

[Robaire Pullicar]

Like mike said fit the safety. If I remember right it explains the process on the yellow card or paper in the package

 

[Matt1911]

Like mike said fit the safety. If I remember right it explains the process on the yellow card or paper in the package

Who reads those though.

 

[Robaire Pullicar]

Who reads those though.

I did AFTER I found my safety was hard as **** to actuate!

 

[dennishoddy]

Who reads those though.

You give up your man card if you admit to reading instructions for anything.