9mm and .40 reloading data

[moonshoxx]

Looking to load for 9mm in Production XDM 5.25 and .40 in Glock 35.

147 gr. Bayou Bullet in 9mm and 180 Montana Gold in .40. Any information you can provide is helpful. Oh yea, powder choice right now is Titegroup for 9mm and WSF for 40. Looking for charge data and OAL.

 

[BLR]

4.3grs of Titegroup will get you to right at or a little above 170pf with the 180's in the 40. 3.9grs of titegroup with 180 bayou's in the .40 will be around 159pf this is a really sweet shooting load. These #'s are all out of a 5in. 2011. aol on both is 1.180 this might be a little long for the guns you are loading for.

 

[moonshoxx]

yea. i think the glock needs to be around 1.125 or so. that is why i am sticking with the WSF for the major.

 

[BLR]

Had a great 3 gun load for a G34 i had it was a 147 loaded with somewhere around 5 grains of HS-6 went around 850fps it was a really good shooting load. I'll see if i can find that recipe.

 

[poopgiggle]

I load 147gr cast lead and 147gr moly (BBI) using the same recipe.

3.2gr Bullseye, 1.14" OAL.

It's cheap to load and really soft shooting but it's really smokey. When I shoot I look like a Civil War reenactor.

 

[dennishoddy]

Last night I loaded up some 180 grain lead flat point, using WST.
Starting load for the M&P .40, 5" was 4.3 grains. On the chrony, I got right at 910 fps average for 5 shots. Upping the load to 4.6 grains, the chrony showed 980 FPS.
Backing off to 4.4, I averaged 950 fps. its close, but it will make major, and was pretty soft. I do run a 13lb spring.