Fix for Snapping Shell Plate on Dillon 650

[jtischauser]

I found this thread on Enos. Fix For Snapping Shell Plate

I was curious as to what you guys have done to you 650 to fix or deal with this problem?

 

[Scott Hearn]

Well I have the bullet tray on mine. So my hand is already just "right there" so I just ease it into position with my hand.

I may do the needle bearing thing, but I've found that I don't even really need the buttons doing it the way I do. But you really need to do something, because they sure will sling the powder if you don't.

 

[Mitch Harrington]

I found this thread on Enos. Fix For Snapping Shell Plate

I was curious as to what you guys have done to you 650 to fix or deal with this problem?

One of the best fixes for that don't cost anything. It helps tremendously in keeping high volume powders from spilling.

 

[TroyF]

I run a 550 and have read some good fixes/tweaks on BE for those as well. I can honestly say, I came up with one tweak on my own, using my wee wittle pea brain.

 

[JxxxOxxxE]

I just added the needle bearing and washers to mine. I haven't loaded anything with it yet, but I can't tell a difference just by watching it.

I was doing what someone else mentioned about placing my hand on it, but for $10, it'll be nice to not have to worry about it...