shooting

HOLY DIVER · Jun 23, 2012

got out to the range with tigerstripe today and had a freaking ball! he has a very neat AR-15 he let me shoot.i realy need to get out and shoot more than just once a week,its great stress reliever!

Tigerstripe · Jun 23, 2012

or just go with us to the range and dump some 30 rd mags full auto.

then switch to 22.25 rd mag dumps,full auto. makes me smile.

next time ill bring the 9mm upper. 32 rd mag dumps, full auto.

and when clicker sends me his 762x39 upper, cause, ahh just cause, we can mag dump 762x39, full auto.

diver did you get it fixed? it should not have been a problem. after you left i dumped one mag ok and tried a second but had to eject 5 of them. loaded them again and they fired. bet its kind of dirty.

HOLY DIVER · Jun 24, 2012

Tigerstripe said:
or just go with us to the range and dump some 30 rd mags full auto.

then switch to 22.25 rd mag dumps,full auto. makes me smile.

next time ill bring the 9mm upper. 32 rd mag dumps, full auto.

and when clicker sends me his 762x39 upper, cause, ahh just cause, we can mag dump 762x39, full auto.

diver did you get it fixed? it should not have been a problem. after you left i dumped one mag ok and tried a second but had to eject 5 of them. loaded them again and they fired. bet its kind of dirty.

oh yea i put an brass cleaning rod down the pipe and tapped that lodged bullet right own(we had a round that the powder did not ignite and the primer pushed the bullet about 6 inches up in the pipe) i can't wait to try that 9mm upper out!

Tigerstripe · Jun 24, 2012

dang, it went 6 inches?

when it has happened to me there werent visible rifling marks. next rd always leaves a mark in the back of the stuck bullet.

i did not pay enough attention while loading some 223 and in 1000, i guess 1 of 50 had retained moisture. the primer goes off although you cant hear it but the powder doesnt ignite. i could never get another rd in because of the blockage but if one goes 6 inches a rd could load.
DONT DO THIS.
ive added another step. check inside cases.