Ordered it straight from C-rums. It was one of his already welded lifters. So far it been feeding fine doing loading drills. So nice not to hang my thumb in there. Now to figure out how to hodl four shells and feed them into it reliably. Getting better but not smooth yet!
Got it done. Only took about 30 minutes. 15 of which was looking for the hammer spring cap. After taking it out of the ziploc it shot out of there like a rocket. Pretty simple little switch. So much better now.
Found the schematic on brownell's. Keep a supply of two gallon zip locks on my gunsmithing bench. Only one pin holding it all together, the hammer, carrier, shell release, etc. Look like hold the shell release tight. Slip the pin out, remove the carrier then slip the pin back in. Take off the...
Anyone have any tips on disassembling the trigger group to change out the lifter. Doesn't look too complicated for someone with a little mechanical knowledge but not exactly sure what little springs may be under something I haven't seen. So any tips before I dig in and start to change out the...
For my first ever match plus first 3 gun I had a blast. Started out intimidated by everything but that went away on the first stage. Then it was down to shooting and I've done lots of that over the years.
Want to thank everyone that was involved with setting it all up. You definitely made the...
I'm in for the class whenever it is. Having never shot any competitions or had any professional training I figure this be a good place to start. Looking forward to it.
Billet Upper/Lower Set
GT - 1 Receiver set
bsmith918 - 1 Receiver set (depending on whether we can get different colors as shown on LOKI's website)
shooterdave - 1. Receiver set. (FDE if we can colors)
Forged Upper
Jesse Tischauser - 1 - 16" Barrel w/Intermediate Gas, PRI Low Profile Adjustable...