Ok guys no flames here but I been shooting/cleaning guns for 30+ years, I don't mess up crowns, as a matter of fact I have fixed a few over the years.
No loose barrel or optics and why all of a sudden does it start deforming bullets if it is at all, I'll check and see.
Thanks again for all the...
Anyone having accuracy problems? Mine shot good(1" +/- at 50 yeards) for the first 200 rounds or so, now even after cleaning I'm lucky if I can get 2.5" at 50
I also posted this in the rifle section!!
Anyone having accuracy problems? Mine shot good(1" +/- at 50 yeards) for the first 200 rounds or so, now even after cleaning I'm lucky if I can get 2.5" at 50
PAID - Calamity Jake - 16" .750 Black Barrel w/Full Length Handguard
PAID - Calamity Jake - 2 - AR-SM-26R Black Dog Machine 26 round magazine for NC22 Upper
I did not order the 26 round mags, I ordered 2 15 round mags as below
"Posted 22 December 2011 - 06:57 PM"
MO went in the mail today...
MO went in the mail today for a 16" .750 Black Barrel part # NC22UP161 comes with mid length HG and a 10 round BG mag.
Plus 2 15 round Black Dog mags and shipping.
MY updated order:16" .750 Black Barrel part # NC22UP161 comes with mid length HG and 10 BG mag.
Add 2 15 round Blackdog mags.
Thanks for doing this group buy.
Order mine with what ever hand guard and top rail that comes standard on the upper,
the 3" rail section installed @ 6 o'clock and the two 15 round mags.
Any kind of wax on the brass makes them slick almost like leaving lube on them, causes excessive bolt thrust in rifles and semi auto pistols.
I use walnut media and a little MS, no waxes. I like my brass clean but it doesn't have to
be shinny.
So after you get the decap rod out of the case put it back in the die with about 1/4 inch of the
pin sticking below the die then tighten the 7/16 nut at the top of the die, this locks the rod
in the die so the case will be pulled over the expander ball instead of pulling it out.
Just to let you...